top of page
37 Park Street, Hyde Park (10)_edited.jpg

Installing floor heating throughout South Australia

335-337 Wakefield St, Adelaide (8)_edited.jpg

In Screed Heating

In Screed heating is the preferred and most affordable choice for heating most bathrooms. It is a direct acting system and is installed just before the tiler screeds the floor. The cable is the same robust design as the in-slab and it is suitable for installation below any stone or tile surface. 

Under Tile Heating

Under Tile heating is a popular choice in renovations where floor height is critical, or where no screed is being applied. Under tile heating is a direct acting system, warming up quickly so it is suitable for using just a few hours a day. This system is installed prior tiling.

2 Francis Street, Nuriootpa, Kirchen, Dining, Living (9)_edited.jpg
13 Claire Street, Lower Mitcham (19)_edited.jpg

In Slab Heating

In Slab heating is the most popular choice for full home heating; here the cables are fixed to the reinforcing steel just before the slab is poured. In-Slab heating is the ideal solution for connection to off-peak tariff or soaking in cheap renewable energy. The concrete slab then acts as a heat sink, storing heat  and releasing it slowly during the day. With this system you can heat your home 24/7 throughout the winter at a reasonable cost. In-Slab heating can be used with most floor coverings, but it is especially popular beneath polished concrete and tiled floors.

Insulation

Without insulation, up to 40% of heat generated by an underfloor heating system could be lost through the sub-floor.

boards_edited.jpg
kit_edited.jpg

Supply of DIY Kits

Install floor heating yourself.

Supply and Install Thermostat

Replace your existing floor heating controller with fully programmable thermostat.

gtsw-dual-v_edited.jpg
str430.jpg

Supply heated towel rails.

Supply RADIANT headed and non-heated towel rails with best possible prices.

Supply 316 Grade Stainless Steel Floor Grates

Radiant tile insert floor wastes and channel drains are manufactured from premium 316 grade stainless steel and are available in a wide variety of sizes and outlets, allowing you to integrate any tile or stone to seamlessly match the rest of the bathroom.

gld-rgl-1-1000px.jpg

Let's Discuss 
Your Next Project

Fill out the form, or call us.

Service Areas:

South Australia

2 Ware Street, Thebarton, 5031, South Australia

0428848982

Upload File

Thanks for submitting!

bottom of page